Component/RGB video connectors
These inputs are suitable for connection to source devices which output Component (YUV or YPbPr) or RgB high quality analogue video signals. These signals are usually available from BD players,
If you are connecting up to an RgB source you may also need to connect the source’s Composite output to the AVR360 Composite input to act as a video sync (‘RgB
+Sync’ format). The Composite signal should be on the same named input as the RgB signals. The AVR360 is also compatible with ‘Sync on Green’ or ‘RgsB’ signals.
RgB video outputs on source equipment are often on SCART connectors. You will need to use a SCART to ‘RgB+Sync on phono’ breakout cable, available from your Arcam dealer.
NOTE
When setting up the AVR360 menus (later in this manual), you will need to select whether the
COMPONENT VIDEO IN SAT, AV, BD
Connect the Component video outputs of your source equipment to these inputs.
COMPONENT VIDEO OUT
Connect this output to the Component video input of your display device.
NOTE
Analogue RgB video output is not available from the AVR360. The analogue
Zone 2 connectors
The Z2 out analogue audio connector can be used to connect the stereo audio output of the AVR360 to an amplifier located in a second room. Connect the analogue video output to your Zone 2 display equipment. See
S-Video and Composite connectors
AV, VCR, BD, SAT
Connect these inputs to the
Digital audio connectors
VCR, PVR, BD, CD, AV, SAT
Connect these inputs to the digital outputs of your available source equipment.
