3M MP8030 manual Turning Off the Projector, Memory Function/Factory Defaults

Mute: Press the MUTE button to turn off the sound to the speakers. Press again to restore the sound.

Note

The volume level is controlled from the remote control transmitter.

Zoom: Press the ZOOM button to adjust the image size to fill the screen. Press and hold down + or

±until the image is the desired size. If you cannot make the image fill the screen, move the projector further back from the screen.

Focus: Press the FOCUS button to adjust the sharpness of the image.

The following on-screen display will appear:

Press and hold down + or ± until the image becomes sharp and clear.

Menu: Press the MENU button to display the names of the system menus across the top of the projection screen. These menus are used to adjust the characteristics of the projected image.MENU

Press the left/right arrow (← MENU → ) to select (highlight) and display each menu. Press the up/down (↑ MENU ↓) arrow or left/right (← MENU → ) arrow again to select (highlight) the desired menu option. See Section 4-5for more about using menus.

++ + FOCUS +++

SETUP INPUT IMAGE OPT.

SETUP INPUT IMAGE OPT.

RGB1

RGB2

VIDEO1 →

VIDEO2 →

TEST

PATTERN

Volume Adjustment: Use the VOLUME button on the remote control to adjust the speaker volume. Press () to increase or () to decrease the volume level. See Section 4-6to set the volume in the Setup menu.

4-2. Turning Off the Projector

Press and hold down the STANDBY/ON button for one second to switch the projector to the standby mode. The one second hold-down period is designed to avoid accidentially turning off the projector if the standby/on button is bumped. The lamp will shut off and the green indicator on the projector panel will turn to

orange. Wait until the cooling fan motor cycles off before you press the Power Off switch.

Note

Switching the power off before the fan has cycled off, will decrease the life of the projection lamp.

4-3. Memory Function/Factory Defaults

The MP8030 will retain all picture adjustment settings you make until you either change them again or return all settings to the factory default.

To return picture adjustments back to the factory settings, press the RESET button on the projector control

panel or remote control transmitter .

 3M 1996 3M  Multimedia Projector MP8030 11