3M MP8610 Section 4: Operating Instructions

3M 1998 3M Multimedia Projector MP8610 7

Section 4: Operating Instructions

Read the Important Safeguards before operating the MP8610 projector. After all cable connections have

been completed, the projector can be powered up. For best results, please observe the following start up

sequence. Refer to Figure 4-1

!Caution

Allow a projector that has been stored in a cold place

to warm up to room temperature before applying

power.

1. Press the power switch (1) to ON to apply

power to the projector (| = ON, O = OFF).

The red LED (3) will illuminate.

2. Press the Standby button (2). The green

LED (3) will illuminate and an image will

appear and grow brighter on the screen.

3. Check all ventilation slots and clear away

any obstructions.

4. Turn the lens (4) to focus the image.

5. Press the foot lock button (5) to release the

height adjustment feet.

6. Raise/lower projector body to extend or

retract feet (6) to obtain best image height.

Rotate feet (7) for fine adjustment.

7. Power up your computer source and video

source(s).

9 Note

In most cases, the projector will automatically adjust

to the graphic mode of your computer by selecting a

pre–programmed setting. See Appendix C-2. Figure 4-1. Projector Setup

When the projector is not being used, place it into standby mode.

1. Press the Standby button.

2. The lamp will switch off and the red LED

will illuminate.

3. Press the standby button again to illuminate

the lamp and project an image on the screen.

9 Note

In standby mode, the fan motor will continue to run

for a few minutes until the projector cools down.

MP8610

8610-11A

123