A&D 2 Plus owner manual Care & Maintenance

	Section 5: Care & Maintenance
Care After the Dive	Annual Dealer Inspections & Factory
	Service

CAUTION: If the Monitor 3 Air transmitter is not attached to a first-stage regulator while soaking (explained below), make sure that water is not allowed to enter the high pressure inlet. Water entering the transmitter may cause damage to the internal components.

After each day of diving, soak the Monitor 3 Air in a warm, fresh water bath to dissolve salt crystals. To dissolve heavy salt buildup, use a slightly acidic vinegar/water bath. After removing the computer from the bath, rinse thoroughly with fresh water. Towel dry the computer before final storage. Place the Monitor 3 Air in a cool, dry and protective case to transport.

The transmitter should be rinsed at the same time the regulator is rinsed. Make sure the transmitter is attached to the first-stage. Connect the first-stage to a charged SCUBA cylinder. Turn on the cylinder valve and submerge the whole regulator/tank system in a bath of water. By applying pressure to the regulator, you absolutely prevent any water from entering the regulator and transmitter.

Factory service was discontinued in 1997. Please contact the original manufacturer, Uwatec, at 800-467-2822.

51