IP Phone Release Notes 2.2
Features in Release 2.2
Ability to Disable Switching Focus to a Ringing Line When on a Call
In Release 2.2, it is now possible to control the behavior of the phone when it receives an incoming call when it is already in a connected call. By default, and in the previous release behavior, the phone switches focus to the ringing line to enable the user to see who is calling them.
In Release 2.2, you can now turn off this functionality so that the phone now stays focused on the connected call. You can do this using the “switch focus to ringing line” parameter in the configuration files or the Aastra Web UI.
Note: If you configure the BLF/Xfer key(s) and/or Speeddial/Xfer key(s) on the phone, you can enable or disable the switching of the user interface focus to ringing line while the phone is in the connected state.
Configuring “Switch Focus to Ringing Line” Using the Configuration Files
You use the following parameter in the configuration files to enable or disable “Switch Focus to Ringing Line”:
•switch focus to ringing line
Parameter – | Aastra Web UI: | Basic | |
switch focus to ringing line | Configuration Files | aastra.cfg, <mac>.cfg | |
|
| ||
Description | Specifies whether or not the UI focus is switched to a ringing line while | ||
| the phone is in the connected state. | ||
|
|
| |
Format | Boolean |
| |
|
|
|
|
Default Value | 1 | (enable) |
|
|
|
|
|
Range | 0 | (disable) |
|
| 1 | (enable) |
|
|
| ||
Example | switch focus to ringing line: 1 | ||
|
|
|
|
74 |
