Abit AW9D-MAX manual Power Management Setup, Acpi

3.6 Power Management Setup

Phoenix – AwardBIOS CMOS Setup Utility

Power Management Setup

ACPI	Suspend Type			S3(Suspend To RAM)	Item Help
- Resume by USB From S3				Enabled
Power Button Function				Instant-Off
Wake	Up	by	PME# of PCI	Disabled
Wake	Up	by	WAKE# of PCIe	Disabled
Wake	Up	by	Onboard LAN1	Disabled
Wake	Up	by	Onboard LAN2	Disabled
Wake	Up	by	Onboard 1394	Disabled
Wake	Up	by	Alarm	Disabled
X - Date(of month) Alarm				0
X - Time(hh:mm:ss) Alarm				0 : 0 : 0
Power On Function				Button Only
X - KB Power			On Password	Enter
X - Hot Key Power On				Ctrl-F1
Restore		On	AC Power Loss	Power Off
↓↑→←:Move		Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit			F1:General Help

F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults

ACPI Suspend Type

This item selects the type of Suspend mode.

[S1(PowerOn Suspend)]: Enables the Power On Suspend function.

[S3(Suspend To RAM)]: Enables the Suspend to RAM function.

-Resume by USB From S3

When set to [Enabled], this item allows you to use a USB device to wake up a system that is in the S3 (STR - Suspend To RAM) state. This item can be configured only if the item “ACPI Suspend Type” is set to [S3(STR)].

Power Button Function

This item selects the method of powering off your system:

[Delay 4 Sec.]: Pushing the power button for more than 4 seconds will power off the system. This will prevent the system from powering off in case you accidentally hit or pushed the power button.

[Instant-Off]: Pressing and then releasing the power button at once will immediately power off the system.

Wake Up by PME# of PCI

When set to [Enabled], access through the add-on PCI card can remotely wake up the system that was in Soft-Off condition. The PCI card must support the wake up function.

3-26 AW9D-MAX, AW9D