Access
Control
WDS Setting
Click the Setup button to enter the Wireless Access Control page.
Wireless Access Control Mode: Select the Access Control Mode from the
•Disable: Select to disable Wireless Access Control Mode.
•Allow Listed: Only the stations shown in the table can associate with the AP.
•Deny Listed: Stations shown in the table won’t be able to associate with the AP.
MAC Address: Enter the MAC address of a station that is allowed to access this Access Point.
Comment: You may enter up to 20 characters as a remark to the previous MAC address.
Apply Changes: Press to save the new settings on the screen.
Reset: Press to discard the data you have entered since last time you press Apply Changes.
Current Access Control List: This table displays you the AP MAC information.
Delete Selected: To delete clients from access to this Access Point, you may firstly check the Select checkbox next to the MAC address and Comments, and press Delete Selected.
Delete All: To delete all the clients from access to this Access Point, just press Delete All without selecting the checkbox.
Reset: If you have made any selection, press Reset will clear all the select mark.
If you select WDS Bridge or WDS Repeater mode, then you can access the WDS Setting setup.
11
