DHCP

DHCP Client Range

Show Client

Disable: Select to disable this Router to distribute IP Addresses (Disabled).

Server: Select to enable this Router to distribute IP Addresses (DHCP Server). And the following field will be activated for you to enter the starting IP Address.

The starting address of this local IP network address pool. The pool is a piece of continuous IP address segment. Keep the default value 192.168.1.1 should work for most cases.

Maximum: 253. Default value 253 should work for most cases.

Note: If “Continuous IP address poll starts” is set at 192.168.1.1 and the “Number of IP address in pool” is 253, the device will distribute IP addresses from 192.168.1.1 to 192.168.1.253 to all the computers in the network that request IP addresses from DHCP server (Router)

Click to show Active DHCP Client Table.

Refresh: Click this button to refresh the table.

Close: Click this button to close the window.

DNS Server

Apply Changes

Reset

Enter the Domain Name Service IP address.

After completing the settings on this page, click to save the settings.

Click to restore to default values.

Other

Upgrade Firmware

25

Page 28
Image 28
Abocom WAP2102 manual Upgrade Firmware, Dhcp Client Range Show Client, DNS Server Apply Changes Reset, Other