Acnodes RMC 7150

All r ights reserv ed. Product descr iption and produ ct specific ations

are sub ject to c hange without not ice. For latest product in formation,

please visit Acnode s’ we b si te a t ww w.acnodes. com.

PC 5150

15-inch touch panel PC

14628 Central Blvd,

Chino, CA91710

tel:909.597.7588, fax:909. 597.1939

RMC 7150

14” short depth rack server

Floppy A

This feature allows the user to select the type of floppy drive connected to the sys- tem as specified. The options are Disabled,

360KB 5 1/4", 1.2MB 5 1/4", 720KB 3 1/2", 1.44MB 3 1/2" and 2.88MB 3 1/2". The default setting for Floppy A is 1.44MB 3 1/

2", and for Floppy B is Disabled.

SATA#1 Configuration

If Compatible is selected, it sets SATA#1 to legacy compatibility mode, while se- lecting Enhanced sets SATA#1 to native

SATA mode. The options are Disabled, Compatible and Enhanced.

Configure SATA#1 as

This feature allows the user to select the drive type for SATA#1. The options are IDE, RAID and AHCI. (When the option-RAID is

selected, the item-ICH RAID Code Base will appear. When the option-AHCI is selected, the item-SATA AHCI will be available.)

ICH RAID Code Base (This feature is available when the option-RAID is selected)

Select Intel to enable Intel's SATA RAID firmware to configure Intel's SATA RAID settings. Select Adaptec to enable Adaptec's

SATA RAID firmware to configure Adaptec's SATA RAID settings. The options are Intel and Adaptec.

SATA AHCI (This feature is available when the option-AHCI is selected)

Select Enable to enable the function of Serial ATA Advanced Host Interface. (Take caution when using this function. This feature

is for advanced programmers only.) The options are Enabled and Disabled. If the option-Enabled is selected, the following item

will display.

SATA#2 Configuration (This feature is available when the option-IDE is selected)

Selecting Enhanced will set SATA#2 to native SATA mode. The options are

Disabled, and Enhanced.

IDE Detect Timeout (sec)

Use this feature to set the time-out value for the BIOS to detect the ATA, ATAPI devices installed in the system. The options are

0 (sec), 5, 10, 15, 20, 25, 30, and 35.

Primary IDE Master/Slave, Secondary IDE Master/Slave, Third IDE Master, and Fourth IDE Master

These settings allow the user to set the parameters of Primary IDE Master/Slave, Secondary IDE Master/Slave, Third and

Fourth IDE Master slots. Hit <Enter> to activate the following submenu screen for detailed options of these items. Set the

correct configurations accordingly. The items included in the submenu are:

Type

Select the type of device connected to the system. The options are Not Installed,

Auto, CD/DVD and ARMD.

LBA/Large Mode

LBA (Logical Block Addressing) is a method of addressing data on a disk drive. In the LBA mode, the maximum drive capacity

is 137 GB. For drive capacities over 137 GB, your system must be equipped with a 48-bit LBA mode addressing.

If not, contact your manufacturer or install an ATA/133 IDE controller card that supports 48-bit LBA mode. The options are

Disabled and Auto.