Adams Condensing Oil-Fired Furnace operation manual Iii. Product Application, rWARNING

III. PRODUCT APPLICATION

This furnace is primarily designed for residential home-heating applications. It is NOT designed or certified for use in mobile home, trailers or recreational vehicles. This unit is NOT designed or certified for outdoor applications. The furnace must be installed indoors (i.e., attic space, crawl space, or garage area prOVided the garage area is enclosed with an operating door).

This furnace can be used in the following non-industrial commercial applications:

Schools, Office buildings, Churches, Retail stores, Nursing homes, Hotels/motels, common or office areas In such applications, the furnace must be installed with the following stipulations:

oIt must be installed per the installation instructions provided and per local and national codes.

oIt must be installed indoors in a building constructed on site.

oIt must be part of a ducted system

and not used in a free air delivery application.

oIt must not be used as a "make-up"

air unit.

oThis furnace may NOT be used as a construction site heater.

To ensure proper installation and operation, thoroughly read this manual for specifics pertaining the installation and application of this roduct.

rWARNING

Possible property damage, personal injury or death due to fire, explosion, smoke, soot, condensation, electrical shock or carbon monoxide may result from improper installation, repair, operation or maintenance of this product.

rWARNING

To prevent personal injury, property damage or death due to fire, do not install this furnace in a mobile home, trailer or recreational vehicle.

To ensure proper fumace operation, install, operate and maintain the furnace in accordance with these installation and operation instructions, all local building codes and ordinances.

INSTALLATION CODES

INSTALLATION MUST COMPLY WITH THE REQUIREMENTS OF AUTHORITIES HAVING JURISDICTION.

All local and national codes governing the installation of oil burning equipment, Wiring, and venting must be followed. Some of the applicable codes are:

CAN/CSA B139 Installation Code for Oil Burning EqUipment.

NFPA 31 Installation Code for oil Burning Equipment

ANSIINFPA 90B Warm Air Heating and Air Conditioning Systems.

ANSIINFPA 70 National Electrical Code. CSA C22.1 Canadian Electrical Code. ANSI/NFPA 211 Chimneys, Fireplaces, Vents and Solid Fuel Burning Appliances.

A copy of the CAN/CSA B139 Installation Codes can be obtained from:

CSA International

178 Rexdale Boulevard

Etobicoke, Ontario, Canada M9WIR3

or

CSA International

8501 East Pleasant Valley

Cleveland, OH 44131

The rated heating capacity of the furnace should be greater than or equal to the total heat loss of the area to be heated. The total heat loss should be calculated by an approved method or in accordance with "ASHRAE Guide" or "Manual J-load Calculations" published by the Air Conditioning Contractors of America.

IV. LOCATION REQUIREMENTS & CONSIDERATIONS

GENERAL

rWARNING

TO PREVENT POSSIBLE EQUIPMENT DAMAGE, PROPERTY DAMAGE, PERSONAL INJURY OR DEATH, THE FOLLOWING BULLET POINTS MUST BE OBSERVED WHEN INSTALLING THE UNIT.

4