18
NOTE: DO NOT WRAP THE HOT SURFACE IGNITOR WIRES AND THE FLAME
ELECTRODE WIRE TOGETHER. IMPROPER OPERATION MAY RESULT.
THEY MAY RUN ALONGSIDE EACH OTHER.
5. Reestablish procedure for installation of new ignitor.
Gas Valve Replacement (Refer to burner illustration on page 11)1. Discontinue electrical power to the dryer.
2. Close shut-off valves in gas supply line.
3. Disconnect gas valve wiring.
NOTE: Identify location of each wire for correct reinstallation.
4. Unscrew (break) union connection before gas valve.
5. Loosen and remove four (4) screws securing pipe brackets to burner.
6. Remove valve and manifold assembly from dryer.
7. Remove valve mounting bracket, manifold and piping from gas valve.
8. Reverse procedure for installing new gas valve.
WARNING: Test ALL connections for leaks by brushing on a soapy water solution.
WARNING: NEVER TEST FOR LEAKS WITH A FLAME!!!
Main Burner Orifices Replacement1. Refer to To Replace Gas Valve and follow Step #1 through Step #6.
2. Unscrew main burner orifices and replace.
NOTE: Use extreme care when removing and replacing orifices. These orifices are made of brass and
are easily damaged.
3. Reverse the removal procedure for reinstalling.
WARNING: Test ALL connections for leaks by brushing on a soapy water solution.
WARNING: NEVER TEST FOR LEAKS WITH A FLAME!!!