23
IMPORTANT: UNDER NO CIRCUMSTANCES should the door switch be disabled.
Main Door Assembly Replacement
1. Open main door.
2. Holding the door upward remove the two (2) screws from the top hinge block.
3. Lift the door up to remove.
4. Reverse this procedure for reinstalling new main door assembly.
To Install New Main Door Glass
1. Remove main door assembly from dryer (follow main door removal procedure).
2. Lay main door on flat surface with the back of the door facing down.
3. Remove the four (4) #10-32 acorn nuts securing the glass to the door.
4. Remove glass and clean ALL old sealant off main door. This area must be clean for correct bonding.
5. Place a bead of silicone (ADC P/N 170730) around the edge door and lightly press glass into place.
6. Reinstall the four (4) #10-32 acorn nuts that were removed in Step #3.
IMPORTANT: DO NOT press hard or silicone thickness between the glass and door will be
reduced, resulting in poor bonding.
7. The door assembly should now be put in an area where it will not be disturbed for at least 24 hours. Depending
on the conditions, the curing time of this adhesive is 24 to 36 hours.
8. After the curing period, install main door on dryer by reversing Step #1.