31
P. MOTORIZED IMPELLOR (BLOWER) REPLACEMENT
1. Discontinue electrical power to the dryer.
2. Remove lint draw.
3. Remove the perforated panel inside the tumbler
(basket).
4. Remove the bolts securing the inlet cone.
5. Remove the inlet cone.
6. Remove the bolts securing the motor plate to the
dryer cabinet.
7. Remove the motorized impellor along with the motor
plate.

NOTE: The motorized impellor assembly will not be able to be removed due to the wiring harness still

connected.

8. Disconnect the wiring harness from motor.
9. Remove the motor plate from the motorized impellor and install it on the new motor.
10.Reconnect the wiring harness to the motor.
11.To replace new motorized impellor assembly, reverse Step #10 through Step #2.
12.Reestablish electrical power to the dryer.
Q. LINT DOOR SWITCH REPLACEMENT
1. Disconnect electrical power to the dryer.
2. Remove the lint door panel.
3. Remove the front panel.
4. Disconnect both 4-pin connectors at the rear
of the lint switch cover.
5. Remove the two (2) screws holding the lint
switch cover on.
6. Remove the lint switch cover and disconnect the two (2) terminals of the switch.
7. Remove switch by pressing tabs together and pushing switch out.
8. Install new lint door switch by reversing these procedures.