30
8. Retighten motor mount bolts and jam nuts.
9. Assemble front panel lint door assemblies back to dryer.
10.Reestablish electrical power to the dryer.
Drive Motor V-Belts Replacement
1. Discontinue electrical power to the dryer.
2. Remove the belt guard cover from the rear of the dryer.
3. Loosen tension on V-belt so that it can easily be rolled off pulley. This can be done by loosening the four (4)
bolts holding the motor to the side of the dryer, as well as the adjustment bolt on top.
4. Replace V-belt.
5. Retighten V-belt and adjust tension and alignment per previous instructions.
O. MOTORSDrive Motor Replacement
1. Discontinue electrical power to the dryer.
2. Remove the belt guard cover from the rear of the
dryer.
3. Remove drive belt.
4. Disconnect wiring harness from motor.
5. Remove bolts holding motor to mount and replace
with new motor. DO NOT TIGHTEN BOLTS.
6. Remove pulley from old motor and install on new
motor. By removing the set screw from the drive
motor pulley.
NOTE: A gear puller may be required to remove pulley.
7. Align motor pulley with drive assembly pulley and tighten set screw holding motor pulley.
8. Replace belts and adjust belt tension.
9. Retighten bolts.
10.Reestablish electrical power to the dryer.