25
F. DRIVE SHAFT PULLEY REPLACEMENT
1. Discontinue electrical power to the dryer.
2. Remove front panel from dryer (Follow front panel
replacement directions on page 24.)
3. Loosen V-belts. Rotate pulley and roll V-belts out of grooves.
4. Remove set screw from the 9 (22.86 cm) pulley.
5. Remove pulley and key.
NOTE: A gear puller may be required to remove pulley.
6. Reverse this procedure for replacement.

NOTE: Pulley must be aligned for proper operation.

Drive Motor Pulley Replacement
1. Discontinue electrical power to the dryer.
2. Remove front panel from the dryer. (Follow front panel replacement directions on page 24).
3. Loosen V-belts. Rotate pulley and roll V-belt out of groove.
4. Remove set screw from the drive motor pulley.
5. Remove pulley and key.
NOTE: A gear puller may be required to remove pulley.
6. Reverse this procedure for replacement.

NOTE: Pulleys must be aligned for proper operation.

G. TUMBLER WHEEL REPLACEMENT ON DRIVE ASSEMBLY (Taper Lock Models)
1. Discontinue electrical power to the dryer.
2. Remove front panel from dryer. (Follow front panel
replacement directions on page 24.)
3. Remove the ten (10) 1/4-20 x 1/4 socket button head screws
from the perforated basket side.
4. Remove wrapper assembly.