Proceed as follows:
Remove the machine’s worktop by unscrewing the two rear retaining screws, pull from the front and slide out the slots, lifting the worktop.
Insert the machine after adjusting the level with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are not kinked or squashed.
Connecting the water supply
Your dishwasher has been built in accordance with the valid regulations governing
Never connect your dishwasher to open hot water appliances and continuous flow heaters!
The supply hose is fitted with a screwed hose connection (to DIN 259) and can be connected to an outlet valve (water tap) with male thread (3/4").
Suitable washers are supplied with the machine. Do not use any washers other than these!
The nut of the screwed hose connection can be tightened by and. If you re- quire a supply hose which is longer than the one supplied, use only the VDE- approved complete hose kit (obtainable from our service centre) continuously and to adequate length.
Never lengthen existing hoses.
Important note! The supply hose must not be kinked, squashed, or twisted. Please ensure careful running.
To avoid reductions in water supply to the kitchen, we recommend you to install a separate tap. Failing this, fit a branch piece to the existing water tap.
Additional installation expenditure (on the building side) can be reduced by use of conventional sink mixers with connection and shutoff valve.
29
