Asante Technologies 1012 Using the 3in1 Port, Interconnecting Hubs on Thin Ethernet Backbone

Using the 3in1 Port

Thin Ethernet Backbone

for Segment B connected to bridge external port with a MAU

AsantéBridge 1012

RJ21	10 BASE-T PORTS	IN or OUT	BNC	AUI
			3-IN-1 UPLINK

		2A/250V Slow Blow Fuse
		Replace Only With Fuse of Same Rating
		THROUGH
RS232	AMS LINK	END
PARTITION	UP=PC
		Spare Fuse in Fuse Holder
	DOWN=TERMINAL
TRAFFIC

Thin Ethernet Backbone for Segment A connected to 3in1 Port BNC connector (bridge hub port)

Terminator AsantéHub 1012

2A/250V Slow Blow Fuse

Replace Only With Fuse of Same Rating

RJ21	10 BASE-T PORTS	IN or OUT	BNC	AUI
			3-IN-1 UPLINK

		THROUGH
RS232	AMS LINK	END
PARTITION	UP=PC
		Spare Fuse in Fuse Holder
	DOWN=TERMINAL
TRAFFIC

AsantéHub 1012

RJ21	10 BASE-T PORTS	IN or OUT	BNC	AUI
			3-IN-1 UPLINK

		2A/250V Slow Blow Fuse
		Replace Only With Fuse of Same Rating
		THROUGH
RS232	AMS LINK	END
PARTITION	UP=PC
		Spare Fuse in Fuse Holder
	DOWN=TERMINAL
TRAFFIC

Terminator

Figure 2-4 Interconnecting Hubs on Thin Ethernet Backbone

❖Note:The terminator may be used either at one end of a T-connector, or at the end of a cable. ❖

Page 2-9