Asante Technologies manual AsantéBridge 1012 Rear Panel, RJ21 Port Connector, 3in1 Port

AsantéBridge 1012 Rear Panel

Quick View

The AsantéBridge 1012 rear panel provides the following connec- tors:

❏50-pin Telco

❏3-in-1 Uplink (network)

❏two LED status indicators for the uplink

❏RS 232 port for PC or terminal connection

❏dedicated AMS link

❏external port for the bridge

	Bridge External			Bridge External		Bridge/Hub
	Port Link/Receive LED			Port Collision LED		RS 232 Port
	Bridge External			Bridge VT100		AMS Out-of-Band		Fan	AC Power AC Line
	Port AUI Connector			Local Management Port		Link Ports			Fuse
									2A/250V Slow Blow Fuse
								Replace Only With Fuse of Same Rating
						THROUGH
RJ21	10 BASE-T PORTS			RS232	AMS LINK
		IN or OUT	BNC	AUI	UP=PC	END
			3-IN-1 UPLINK	PARTITION	DOWN=TERMINAL				Spare Fuse in Fuse Holder
				TRAFFIC
					Through/End		PC/Terminal
					DIP Switch
							DIP Switch
RJ21 Port Connector 3in1 Port:				3in1 Port Partition					On/Off Switch
	RJ45 In/Out			and Traffic LEDs
	BNC
	AUI

Figure 1-5 AsantéBridge 1012 Rear Panel

RJ21 Port Connector

Used for linking the twelve hub 10BaseT ports directly through a telephone punchdown block; the RJ21 ports are in parallel to the RJ45 ports on the front of the unit, but they cannot be used simultaneously with the RJ45 ports. For example, if port 5 is used on the front panel (RJ45), you cannot also use port 5 on the RJ21 port.

3in1 Port

This is a single port with three different possible media options. The port provides a network link between the hub (not the bridge) and another hub or a network backbone.You can use any one of the three types of connectors:AUI, BNC, or RJ45 In/ Out.

Page 1-9