:ANAPURNA XL² | OPERATOR MANUAL |
Remark: The engine has also a parameter ‘Mark Center Offset’ for this which is default set on value ‘5000’ means 2.5 cm besidesthe image edge.
This value can be changed by the technician, but if this value is made higher, the bidirectional alignment value has to be changed accordingly, and you will be restricted in total image width if you want to print at another time at full width of the engine onto your media (the extra displacement counts off of your maximum image width). For that we advise to add the blanco space in Wasatch and leave the engine setting unchanged.
9.2.3.Vacuum
Withrigidmedia,thevacuumsettingsmustbechosen accordingthecoveredareaon theconveyorbelt.Whenprintingontworigidmedia,ac tivateboththevacuumtables (1&2).(moreinfo:seechapter7.1)
9.3.MediaTensionBars
Theenginehasgotonerollerbaratthefront,andone attheback. Theyarelocatedunderneaththefrontandbackcovers .Thesebarswillhelptokeep themediaflatwhileit’sbeentransportedonthecon veyorbelt. ItcanbeusedonRollmedia,aswellasonrigidmedi a.
Youcanlowerthebars,byswitchingthe“FRONT”or“R EAR”buttons.
Whenyou’vetakenoutabar,andwanttoreinsertit:
Makesurebothside’sarepositionedashighaspossibl eintotheleft andrightunit,thengentlylowerbothsides,thebar muststaycompletely horizontalforbestuse.
AB]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]]33] | 8/08/2008] |
