Initiate Subsystem
INIT
INIT:CONT
This subsystem enables the trigger system. When a trigger is enabled, an event on a selected trigger source causes the specified trigging action to occur. If the trigger subsystem is not enabled, all trigger commands are ignored. If INIT:CONT is OFF, then INIT enables the trigger subsystem only for a single trigger action. The subsystem must be enabled prior to each subsequent trigger action. If INIT:CONT is ON, then the trigger subsystem is continuously enabled and INIT is redundant.
Command Syntax | INITiate[:IMMediate] | ||
| INITiate:CONTinuous <bool> | ||
Parameters | For INIT[:IMM] | (None) | |
| For INIT:CONT | 01OFFON | |
*RST Value | OFF |
|
|
Examples | INIT INITIATE:IMMEDIATE | ||
| INIT:CONT 1 | INITIATE:CONTINUOUS 1 | |
Query Syntax | For INIT[:IMM] | (None) | |
| For INIT:CONT | INIT:CONT? | |
Returned Parameters | <NR1> | 01 |
|
Related Commands | ABOR <GET> | *RST TRIG *TRG | |
Measure Subsystem
MEAS:CURR?
MEAS:VOLT?
This query subsystem returns the voltage and current measured at the power supply's sense terminals.
Query Syntax | MEASure:CURRent[:DC]? | MEASure:VOLTage[:DC]? | |
Parameters | (None) |
|
|
Default Suffix | A for MEAS:CURR? | V for MEAS:VOLT? | |
Examples | MEAS:CURR? MEAS:VOLT? | MEASURE:VOLTAGE:DC? MV | |
Returned Parameters | <NR3> |
|
|
38 Language Dictionary
