Agilent Technologies 668xA Table B-1. ARPS Commands, ARPS Command1, Similar SCPI, Description

	Table B-1. ARPS Commands
ARPS Command1	Description	Similar SCPI
		Command
VSET x	These commands program output voltage. See Table 3-1 for the	VOLT
VSET xV	programming ranges of these commands.
VSET xMV	Initial condition: 0 V
ISET x	These commands program output current. See Table 3-1 for the	CURR
ISET xA	programming ranges for these commands.
ISET xMA	Initial condition: 0 A
VSET?	These commands read voltage or current settings.	VOLT?
ISET?		CURR?
VOUT?	These commands measure and read output voltage or current.	MEAS:VOLT?
IOUT?		MEAS:CURR?
OVP x	NOTE: OVP commands do not work with Agilent 603xA	VOLT:PROT
OVP xV	supplies. These commands program the overvoltage protection.
OVP xMV	The OVP setting is programmed in either volts or millivolts. See
	Table 3-1 for the programming ranges of these commands.
	Initial condition: 10% above rated output.
OVP?	This command reads the OVP setting.	VOLT:PROT?
VMAX x	These commands program an upper limit (soft limit) to the voltage	(None)
VMAX xV	programming value that the power supply will accept. The
VMAX	programming ranges are the same as those used for VSET.
xMV
IMAX x	These commands program an upper limit (soft limit) to the current	(None)
IMAX xA	programming value that the power supply will accept. The
IMAX	programming ranges are the same as those used for ISET.
xMA
VMAX?	These commands read the soft voltage or current limits.	(None)
IMAX?
DLY x	These commands program the delay time before a new output	OUTP:PROT:DEL
DLY xS	voltage or current is implemented or an RST, OUT ON, or CLR
DLY xMS	command is received. During the delay the CV, CC, and CR
	conditions cannot be reported as faults, and foldback protection is
	disabled.
DLY?	This command reads the delay time setting.	OUTP:PROT:DEL?
OUT OFF	These commands enable or disable the power supply output. The	OUTP:STAT OFF
OUT 0	disabled state programs the output to relatively low voltage and	OUTP:STAT 0
OUT ON	current values. The supply will be able to implement commands	OUTP:STAT ON
OUT 1	even while the output is disabled.	OUTP:STAT 1
	Initial condition: OUT ON
FOLD OFF	These commands enable or disable Foldback protection.	(None)
FOLD CC	Foldback protection disables the power supply output if the power
FOLD 2	supply switches to whichever mode (CV or CC) is defined as the
FOLD 0	fold (error) condition. Note that foldback protection is disabled
FOLD CV	during the DELAY period.
FOLD 1	Initial condition: FOLD OFF
FOLD CC
FOLD 2
FOLD?	This command reads the Foldback setting.	(None)

1 x = any digit (within range) MA = milliampere MV = millivolt MS = millisecond.

64 Compatibility Language