Agilent Technologies E2251A user manual Module Field Wiring Information

M-Module Field Wiring Information

The following section provides a brief, summary of the field wiring for each Hewlett-Packard M-module. It includes a connector pin-out table, a simplified schematic, and a connector drawing. For additional information about a specific M-Module, refer to the respective M-Module’s User’s Manual.

Caution Do not exceed the voltage and current specifications for the individual modules.

Caution All installation, wiring, and configuration procedures are to be done with power DISCONNECTED from the VXI mainframe and power DISCONNECTED from any external wiring/cabling.

WARNING To prevent electric shock, tighten all faceplate and mounting screws when installing M-Modules on the Carrier and the field wiring connector mounting screws.

Assembling the M-Module Field Wiring Connector

Most M-Modules come supplied with a 44-pin connector and matching hood with strain relief (kit part number E2251-01203). You must supply your own cable. The figure on the next page shows how to assemble the connector and hood.

Note	Do not assemble the hood to the connector for the two internally-mounted M-Modules. Strain
	relief can be provided by wire ties through holes in the Carrier.

21