ENGLISH
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(2)1/2" wrenches
(1)9/16" wrenches
(1)3/4" wrench or adjustable wrench
Before assembling the aerator, lay out all of the parts and hardware as shown on the previous pages.
(O) ANGLE HITCH ARM BRACKET MOUNT
BRACKET
(G) 5/16" NYLOCK NUT
(D) 5/16" x 1"
HEX BOLT
Spike points are sharp. Exercise caution when handling and working near spike disks.
1.Assemble the end plates to the inside slots at each end of the tray using two 5/16" x 1" hex bolts (D) and 5/16" nylock nuts (G) per end plate. Do not tighten yet. See figure 1.
2.Assemble the lift plate (P) and the axle support bracket to the tray using four 5/16" x 1" hex bolts (D) and 5/16" nylock nuts (G). Do not tighten yet. See figure 1.
(D) 5/16" x 1" |
|
HEX BOLT | (D) 5/16" x 1" |
| |
| HEX BOLT |
(P) LIFT PLATE |
|
| (G) 5/16" NYLOCK NUT |
AXLE |
|
SUPPORT |
|
BRACKET |
|
FIGURE 1 | FRONT VIEW |
3.Turn the tray upside down as shown in figure 2 so that the rear of the tray (four holes in the bottom) is facing you. Assemble two hitch arm mount brackets and two angle brackets (O) to the bottom of the tray using four 5/16" x 1" hex bolts (D) and 5/16" nylock nuts (G). Do not tighten completely. See figure 2.
FIGURE 2 | REAR VIEW |
4.Pivot the end plate on your right side down out of the way. Place the long end of the axle, measured from the middle blind hole, through the pivot plate on your left side. (If there are two middle holes, use the hole that is in alignment with the end holes.) Fit the middle hole in the axle down onto the tab on the axle support bracket.
See figure 3.
5.Assemble the following parts in sequence onto the short end of the axle (as shown in figure 3):
a.A flat washer (H), short spacer (N), disk hub (L) and spike disk
b.A long spacer (M), disk hub (L) and spike disk.
c.A long spacer (M), disk hub (L) and spike disk.
d.A long spacer (M), disk hub (L) and spike disk.
e.A long spacer (M), disk hub (L) and spike disk.
f.Two short spacers (N), a disk hub (L) and spike disk.
g.A short spacer (N).
(H) FLAT |
| (L) DISK | SPIKE | (N) SHORT | |
WASHER |
| HUB | DISK | SPACER | |
(N) SHORT | (M) LONG |
|
| ||
SPACER |
|
| |||
SPACER |
|
| |||
|
|
|
| ||
|
|
| SHORT | END | |
|
|
|
| ||
LONG | END |
|
|
|
|
|
|
|
|
| |
|
|
| AXLE SUPPORT | ||
|
|
| BRACKET | ||
HOLE |
| TAB |
|
| |
FIGURE 3 |
|
|
|
| REAR VIEW |