Aiphone installation manual Connections IS-DV and IS-DVF, Close it until it clicks

■Connections (IS-DV and IS-DVF)

Electric door strike *1

φ0.65-1.2mm (22-16 AWG)

10m (33')

AC transformer

PT

φ0.65-1.2mm (22-16 AWG)

10m (33')

φ0.65-1.2mm (22-16 AWG)

10m (33')

*Connect to the electric door strike according to its specifications.

NC COM NO

CAT5e/6
(non-shielded)
D	D1	D4
300m (980')	(Select one port.)		Central control unit
			(IS-CCU)

or

CAT5e/6

(non-shielded)
	D1	D8
300m (980')	(Select one port.)		Add-on control unit
			(IS-SCU)

Option	Inlet	*	The terminals are inside the terminal
wires			cover. After connecting, route the
			wires through the wiring paths, then
			close the cover.
		*	Be sure to route the CAT5e/6 cable
			and option wires through inlet.
		*	When closing the terminal cover,
CAT5e/6 cable		Terminal cover	close it until it clicks.

*1: Output specifications

Output method	N/O or N/C dry closure contact
Voltage between	24V AC, 0.5A (resistive load)
terminals	24V DC, 0.5A (resistive load)
	Minimum overload (AC/DC):
	100mV, 0.1mA

NOTES:

•Do not use the unoccupied terminals and ports for other purposes.

•In order to prevent miswiring, label both ends of each cable with the unit and terminal names to which they are to be connected.

•For connecting other manufacture’s products, refer to the instruction manuals for those products.

•The illustration of the unit’s rear panel differs from the actual one. This is for simplifying the connection diagram.

22