User’s Manual
EN
Troubleshooting
If your projector does not seem to be functioning properly, check the items below before you contact an authorized service center.
Symptom |
| Check Point |
The projector can not | ● | Check if the USB Cable is plugged correctly. |
be turned on. | ● | Make sure the PC has been switched to projector |
| ||
|
| display. |
|
|
|
The projected image is | ● | Use the projector in a darker environment. |
too dark. | ● | Increase the brightness by using the AC power |
| ||
|
| adapter. |
| ● Decrease the size of projected image. | |
|
|
|
The projected image is | ● | Adjust the focus. Please refer to “Adjusting the |
dim. |
| Focus”. |
| ● Check if the lens is dirty. | |
|
|
|
The surface | ● | Because of the |
temperature of |
| normal for this projector to generate heat in |
projector ascended. |
| |
|
| of projector. The projector case will help to dissipate |
|
| heat so that its surface temperature will ascend. |
|
| Always keep the ventilation slots free of dirt or |
|
| obstructions and operate the projector in a properly |
|
| ventilated environment. |
Reset Your Device
Occasionally, you may need to reset your Micro Projector. |
|
This can be useful when a program is not performing |
|
properly. |
|
Locate the small hole on the down of the device shown as |
|
the RESET. | Reset Hole |
Using the tip of paper clip, gently push the button inwards. |
www.aiptek.eu | Page 22 |
|
|
