Aiwa AV-D55 manual Selection of AUDIO/VIDEO Source, About the video source to the monitor or TV

SELECTION OF AUDIO/VIDEO

SOURCE

FUNCTION Function indicators ENTER

DOWN;UP I MU~Tl JOG

VIDEO 1/5.1CH/BAND

1Select the program source.

Turn the FUNCTION selector or press the TAPE MONITOR button. The selected function indicator flashes in red.

I TaDe	I TAPE MONITOR		I
I Radio	I TUNER		I
Record	PHONO
Compact disc	CD
Television, etc.	AUX
Video	VIDEO	l/DVD/MD,
	VIDEO	2/LD/TV, VIDEO 3
I LD or Cable TV	I VIDEO	2	I
I MD or DVD	I VIDEO	l/DVD/MD	I

To select a function on the remote control

Press the desired function button directly.

The function to be selected (except PHONO) depends on the equipment connected to the input terminals on the rear panel of the unit.

When using a turntable with a built-in equalizer amplifier, set the switch of the equalizer amplifier to off. Seethe instructions of the turntable for further information.

2Start the selected program source.

3Adjust the sound.

About the video source to the monitor or TV

Selected video source

V1 : VIDEOI , V2: VIDE02, V3: VIDE03

The selected video source is indicated on the display and the video signal through the MONITOR VIDEO OUT jack is output on the TV.

To select the video source

1Trun the FUNCTION to select PHONO, CD or AUX.

2 Press the ENTER button to display VIDEO 1.

3 Turn the MULTI JOG to select VIDEO 2 or VIDEO 3.

To change a displayed name for the VIDEO 1 and VIDEO 2

When the VIDEO 1 is selected, VIDEO 1 is displayed initially. It can be changed to DVD or MD.

Press the VIDEO l/5.1 CH/BAND button while pressing the ENTER button.

To use the 5.1 CH function, press the VIDEO l/5.1 CH/BAND button. The function name will change to “5.1ch IN” and the source connected to the 5.1 INPUT terminals is selected.

To resume, press the button again so that the selected function name is displayed.

The displayed name for VIDEO 2 button can be changed to VIDEO 2, LD orTM while the VIDEO 2 function is selected, press the VIDEO 1/5.1 CH/BAND button while pressing the ENTER button.

To adjust the sound level of the connected source

The input sensitivity level of each function (except the TUNER function) can be adjusted.

When the sound level of the connected source is higher or lower than that of the TUNER, adjust it as follows.

1 Select the function to be adjusted.

Turn the MULTI JOG accordingly and play the source.

2Press the UP or DOWN button repeatedly.

The level can be adjusted between -6dB (MIN) and +8dB (MAX) in 2dB steps. Adjust the level so that the sound is output at the same level as the TUNER.

●The input sensitivity level of the TUNER function cannot be adjusted.

●That of the TAPE MONITOR cannot be adjusted either.

Even if the TAPE MONITOR is selected and the TAPE MONITOR indicator turns red, pressing the UP or DOWN button will change the level of the function displayed on the window.

1 I ENGLISH