To change the AM tuning interval (except for European model)
The AM tuning interval is
9kHz (or 10 kHz for some areas). To change the AM tuning interval, tune in any AM station first, then turn off the system. While holding M> on the unit, press ?/1 on the unit. When you change the interval, all the AM preset stations are erased. To reset the interval, repeat the same procedure.
Note
You cannot change the AM tuning interval in Power Saving Mode (page 20).
Tips
•The preset stations are retained for about a day even if you disconnect the power cord or if a power failure occurs.
•To improve broadcast reception, adjust the supplied antennas, or connect a commercially available external antenna.
Listening to the radio
You can listen to a radio station either by selecting a preset station, or by manually tuning in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner’s memory first (see “Presetting radio stations” on page 13).
1 Press TUNER BAND (or FUNCTION repeatedly) to switch the function to tuner.
2
3
4 Press . or > repeatedly to select the desired preset station.
Listening to non-preset radio station
— Manual Tuning
1 Press TUNER BAND (or FUNCTION repeatedly) to switch the function to tuner.
2
3 Press TUNING MODE repeatedly until “AUTO” and “PRESET” disappear from the display.
4 Press TUNING + or – repeatedly to tune in the desired station.
Note
When tuner function is selected as the current function and CD is pressed to select CD during “CD POWER OFF”, it may take some time to switch the function (page 14).
Tuner
continued