Notes on discs

•Before playing, clean the disc with a cleaning cloth. Wipe the disc from the center out.

•Do not use solvents such as benzine, thinner, commercially available cleaners or anti-static spray intended for vinyl LPs.

•Do not expose the disc to direct sunlight or heat sources such as hot air ducts, nor leave it in a car parked in direct sunlight.

•Do not use discs encircled with a protection ring. This may cause a malfunction to the system.

•When using discs that have glue or similar tacky substance on the label side of the disc or that used a special ink when the label was printed, there is a chance that the disc or label may become attached to parts inside this unit. When this occurs, it may not be possible to remove the disc, and may also cause this unit to malfunction. Be sure to check that the label side of the disc is not sticky before using.

The following types of disc should not be used:

–Rental or used discs with attached seals where the glue extends beyond the seal. The perimeter of the seal on the disc is tacky.

–Discs that have labels printed using a special ink that feels tacky when touched.

•Discs with non-standard shapes (e.g., heart, square, star) cannot be played on this unit. Attempting to do so may damage the unit. Do not use such discs.

Cleaning the cabinet

Clean the cabinet, panel and controls with a soft cloth slightly moistened with mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent such as thinner, benzine or alcohol.

Disc cleaning

Do not use a commercially available CD/DVD lens cleaning disc with this system, as this may result in malfunction.

Specifications

Main Unit (CX-LZP5/LZP3/LZP1)Amplifier sectionFor the U.S. modelAUDIO POWER SPECIFICATIONS

POWER OUTPUT AND TOTAL HARMONIC DISTORTION:

With 6-ohm loads, both channels driven, from 120 – 10,000 Hz: rated 20 watts per channel minimum RMS power, with no more than 10% total harmonic distortion from 250 milliwatts to rated output.

North American model:

Continuous RMS power output (reference): 20 + 20 W

(6 ohms at 1 kHz, 10% THD)

Total harmonic distortion less than 0.9% (6 ohms at 1 kHz, 10 W)

European model:

DIN power output (rated): 16 + 16 W

(6 ohms at 1 kHz, DIN)

Continuous RMS power output (reference): 20 + 20 W

(6 ohms at 1 kHz, 10% THD)

Music power output (reference):

40 + 40 watts (6 ohms at

1 kHz, 10% THD)

Other models:

The following measured at 110 – 120, 220 – 240 V AC, 50/60 Hz

DIN power output (rated): 16 + 16 W

(6 ohms at 1 kHz, DIN)

Continuous RMS power output (reference): 20 + 20 W

(6 ohms at 1 kHz, 10% THD)

Inputs

MD (RCA pin jacks): Sensitivity 500 mV, impedance 47 kilohms

Information Additional

continued

35GB