Connecting an optional USB component
(AWP-ZP5 only)
This system has two USB hub ports. By using this system’s USB hub ports, you can operate USB components from a computer through this system. You can connect an optional USB component with a maximum current consumption of 100 mA or less to each port. For details on compatible USB components, refer to the operating instructions “USB Hub Port Information” provided with this system.
1 Connect the system to a computer with the supplied USB cable (see “Connecting a personal computer to the system” on page 22).
When the system power is turned on, the USB indicator lights up.
USB indicator
2 Connect an optional USB component to this system’s USB hub port.
If the USB indicator turns off
The connected USB component has a maximum current consumption in excess of 100 mA, so it cannot be used with this system. The USB STATUS lamp on the unit lights up. In this case, follow the procedures below.
1Disconnect the optional USB component from this system.
2When instructions are displayed on the PC monitor, please follow them.
If any instructions are not displayed on the PC monitor, disconnect the USB cable from personal computer and reconnect it.
If the USB STATUS lamp on the unit does not turn off after performing the above measures, restart the computer.
Notes
•You cannot use a USB component with a maximum current consumption in excess of 100 mA.
•When connecting this system’s USB hub ports to
•Operation is not guaranteed for all the recommended USB components.
•Operation is not guaranteed when the computer and the system are connected through a USB hub or a USB extension cable.
•Do not connect a USB bus power hub port (that receives power from other components) to this system’s USB ports.
•When the USB component has an AC power adaptor, be sure to connect the AC power adaptor to a power supply.
Tips
•This system’s USB hub is a
•You can use the optional USB component even when;
–The system power is turned off.
–The function selection is other than PC.