Aiwa CX-NMT50 Basic Operations, Playing Discs, Selecting a track with the remote control, English

BASIC OPERATIONS

Press the CD button, then press the A OPEN/ CLOSE button to open the disc compartment. Load disc(s) with the label side up.

To play one or two discs, place the discs on tray 1 and 2.

To play three discs, press the DISC CHANGE button to rotate the trays after placing two discs. Place the third disc on tray 3. Close the disc compartment by pressing the 4 OPEN/CLOSE

Tray 1

Tray number of the

disc to be played Total playing time

Total number of tracks

PLAYING DISCS

Load discs.

To play all discs in the disc compartment, press the <F button.

Play begins with the disc on tray 1,

Elapsed playing time

Number of track being played

To play one disc only, press one of the DISC DIRECT PLAY buttons.

The selected disc is played once.

To play with the remote control

Press the DISC DIRECT PLAY button, then press one of the numbered buttons 1 to 3 within 3 seconds to select a disc.

To stop play, press the ■ button.

To pause play, press the [I button.To resume play, press again. To search for a particular point during playback, keep the

44or - button pressed and release the button at the desired point.

To skip to the beginning of a track during playback, press the + or > button repeatedly.

To remove discs, press the 4 OPEN/CLOSE button.

To start play when the power is off (Direct Play Function) Press the CD button. The power is turned on and play of the loaded disc(s) begins.

When the 4 OPEN/CLOSE button is pressed, the power is also turned on.

To check the remaining time

Press the CD EDIT/CHECK button during play. The amount of time remaining until all tracks finish playing is displayed. To restore the playing time display, repeat the above.

Selecting a track with the remote control

1Press the DISC DIRECT PLAY button, then press one of the numbered buttons 1 to 3 within 3 seconds to select a disc.

2Press the numbered buttons and the +1O button to select a track.

Example:

To select the 25th track, press the +1O, +10 and 5 buttons. To select the 10th track, press the +1O and O buttons.

The selected track starts to play and continues to the end of that disc.

Replacing discs during play

While one disc is playing, the other discs can be replaced without interrupting play.

1Press the DISC CHANGE button.

2Remove the discs and replace with other discs.

3Press the A OPEN/CLOSE button to close the disc compartment.

m

●When loading an 8-cm (3-inch) disc, put it onto the inner circle of the tray.

●Do not place more than one compact disc on one disc tray. “Do not tilt the unit with discs loaded. Doing so may cause

malfunctions.

9 ENGLISH