Aiwa CX-NMT50 Play With Dolby Pro Logic, Additional Dolby Pro Logic Modes, About the channels

If the surround speakers level of the SURROUND is changed (see pa!]e 7), that of the DOLBY PRO LOGIC is also changed.

About the channels

The left and right speakers create the stereo effect.

The center speaker helps achieve precise sound positioning over a broad sound field.

The rear-mounted surround speakers enhance the “depth”of the sound field.

To chi~nge the delay time

The surround speakers reproduce sounds a split second after the front speakers, The delay is initially set to 21 ms (milliseconds),

To change this standard delay time, press the MANUAL SELECT (TEST) button on the remote control repeatedly until “TIME is displayed. Then, press the DOWN K or UP W button. Each

To change the sound levels during playback

After adjusting the balance with the noise sequencer, the SOUnCf

levels of the center or surround speakers can be adjusted during

playback of laser discs or video software.

1Press the MANUAL SELECT (TEST) button on the remote control repeatedly to select “CEN” (center) or “SLJF?” (surround).

2While the “CEN”or “SUR is displayed, press the DOWN 11<4 ~~ or UP FM button on the remote control to adjust the volume.

a!

ADDITIONAL DOLBY PRO LOGIC MODES

In addition to the NORMAL mode, this unit is also equipped with the PHANTOM and the 3 CH LOGIC modes,

PHANTOM mode: Use this mode when no center speaker is connected. The center channel signals are output through the left and right speakers.

time olne of the buttons is pressed, the delay time changes as shown below.

15MS+21MS~30MS

PLAY WITH DOLBY PRO LOGIC

DOLBY PRO LOGIC

3 CH LOGIC mode: Use this mode when no surround speakers are connected. This mode reproduces rear sounds through the front speakers.

To select PHANTOM or 3 CH LOGIC

Press the DOLBY PRO LOGIC button repeatedly until the desired Dolby Pro Logic mode is displayed. The Dolby Pro Logic mode is displayed cyclically as follows,

~NORMAL+ PHANTOM -* 3 CH LOGIC ,

To adjust the balance of connected speaker sound Ievells

Carry out steps 2 to 4 on page 17.

m

“Depending on the sound source and/or listening conditions, a surround effect may not be obtained even when the DOLBY PRO LOGIC is on. -

m

DOLBY

PRO LOGIC

1 Pre!ss the VIDEO/AUX button and start playback of the video source.

2 Press the DOLBY PRO LOGIC button.

NCWiMALis selected, and the playback sound has the DOLBY PFio LOGIC effect.

To camcel Dolby Pro Logic mode

Press the DOLBY PRO LOGIC button repeatedly until P-OFF is displayed.

●The full DOLBY PRO LOGIC effect cannot be obtained vvhen using software without DO~OOL~SURROUNDI mark. In this case, use the SURROUND system instead. (See page 7.)

ENGLISH18