Aiwa CX-NMT50 Remote Control, Connecting An Outdoor Antenna, AM loop antenna, Inserting batteries

To stand the AM antenna on a surface

Fix the claw to the slot.

To position the antennas

FM feeder antenna:

Extend this antenna horizontally in a T-shape and fix its ends to the wall.

AM loop antenna:

Position for the best reception.

m

●Be sure to connect the speaker cords correctly. Improper connections can cause short circuits in the SPEAKERS terminals.

●Do not leave objects generating magnetism near the speakers.

●Do not bring the FM antenna near metal objects or curtain rails.

●Do not bring the AM antenna near other optional equipment, the stereo system itself, the AC cord or speaker cords, since noise will be picked up.

●Do not unwind the AM antenna wire.

To mount the surround speakers on the wall Mount each speaker on a s~ot that can hold its weight.

m

Sound is not heard from the surround speakers when the SURROUND is set to off.

To connect the supplied TS-W35 (only for NSX-MT55) Connect the SUPER WOOFER jack on the main unit to the INPUT jack on the TS-W35 with the supplied connecting cord.

Refer to the Operating Instructions in detail.

CONNECTING AN OUTDOOR ANTENNA

For better FM reception, use of an outdoor antenna is recommended.

Connect the outdoor antenna to the FM 75 Q terminals.

To connect other optional equipment+ page 23.

REMOTE CONTROL

Inserting batteries

Detach the battery cover on the rear of the remote control and insert two R6 (size AA) batteries.

R6;AA)

When to replace the batteries

The maximum operational distance between the remote control and the sensor on the main unit should be approximately 5 meters (16 feet). When this distance decreases, replace the batteries with new ones.

Using the remote control

The instructions in this manual refer mainly to the buttons on the main unit. Buttons on the remote control with the same names as those on the main unit can be used as well.

m

●If the unit is not going to be used for an extended period of time, remove the batteries to prevent possible electrolyte leakage.

●The remote control may not operate correctly when:

-The line of sight between the remote control and the remote sensor inside the display window is exposed to intense light, such as direct sunlight

-Other remote controls are used nearby (those of a television, etc.)

5 ENGLISH