Aiwa XR-M75 Prew CLOCIVDIMMER once, then press ENTER, W!in 4 seconds, To cancel the sleep timer

----,, 1 ,—

1

2-2

Pre:w CLOCIVDIMMER once, then press ENTER	The unit can be turned off automatically at a specified time.
W!in 4 seconds.
	Use the remote control.
	1 Press SLEEP while pressing SHIFT.

When using the remote control

Press CLOCK while pressing SHIFT, then press llSETu!il.hh

4seconds.

Turn MULTI JOG to designate the hour, then press

ENTER.

The hour stops flashing and the minute stark flashing.

Turr~ MULTI JOG to designate the minute, then press ENTER.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press CLOCK/DIMMER once. The time is displayed for 4 seconds.

However, the time cannot be displayed during recording.

l-o swilch to the 24-hour standard

Press ICLOCK/DIMMER once and then press ■ within 4 second f,.

Repeat the same procedure to restore the 12-hour standard.

LIf the clock.display flashes

This is caused by a power interruption, The current time needs to be reset

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

. 44 and * are also avai/ab/e instead of MULTI JOG.

*: //SET is ako avai/ab/e instead of ENTER.

2 Within 4 seconds, turn MULTI JOG or press U or ~ to specify the time until the power is turned off.

The time changes between 5 and 240 minutes in 5-minute

steps.

Specified time

I

To check the time remaining until the power is turned off

Press SLEEP once while pressing SHIFT. The remaining time is displayed for 4 seconds.

To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that “SLEEPOFF appears on the display.

ENGLISH ‘14