148
MVP MANUAL
(3) To set the system back to 4-screen magnification [@ command]
Input: @h (h=8 or 9)
Explanation: •For setting the system back to 4-screen magnification after convergence adjustment, etc.
•Used also when the normal 4-screen magnification output cannot be obtained due to incorrect
operations, etc.
@8 ................... (Sets 4-screen magnification of the OPTION input)
@9 ................... (Sets the 4-screen magnification of the V IN input)
NOTE) An input board must be added in order to display the image of the OPTION input. (Option)
2. Adjusting the picture frame(1) To perform fine adjustment of the picture frame [&G command]
Input: &Gh
Explanation: • Performs fine adjustments of the picture frame of the screen specified by the parameter h value.
h : VOUT output No. (0 to 3)
The parameter h value is as shown in the following figure when viewed from the front.
01
23
•Picture frame fine adjustment command. If the picture frame moves considerable, first perform
coarse adjustments of the picture frame using the &P2 command and &Q2 command. (Refer to
page 149.)
When &Gh is executed, the following is shown on the computer display.
&G3 (Bottom right screen of 4-screen)
+F –F: The horizontal and vertical adjustment values are output at the +F and –F positions.
: Input the following commands after .
0 : To reset the picture frame fine adjustment data
L : To move the screen to the left
R : To move the screen to the right
U : To move the screen up
D : To move the screen down
: Ends the adjustment mode