Akai RMD-V3104U (2) To perform coarse adjustments of the picture frame [&P2, &Q2 commands]

149
MVP MANUAL
(2) To perform coarse adjustments of the picture frame [&P2, &Q2 commands]
Input: &P2d2h1h2h3, &Q2d2h1h2h3
Explanation: &P2 command: Horizontal direction
&Q2 command: Vertical direction
d2 : Screen position (1 to 2)
h1h2h3 : crew start position data (&P2:000 to 1C5, &Q2:000 to 20A)
Although the data is an absolute value, the relative value with the current data can also be speci-
fied.
•Input: &P2d2 + , &P2d2 –
&Q2d2 + , &Q2d2 –
d2: Screen position (1 to 2)
+ : Left direction (horizontal), and up direction (vertical) looking at the screen.
– : Right direction (horizontal), and down direction (vertical) looking at the screen.
: Adjustment mode end
&P2d2
*** : Input the current value at ***
+–+–
&P2d2
***
RES : RES is the initial value
&P2d2
***
100 : Input the value after checking the current value
•The screen start position is the position of the screen actually displayed in respect to the magni-
fied image.
Position displayed on the screen
• This command is used for the coarse adjustment of the picture frame when the adjustment range
is exceeded with the &G command.
• The data shift amount is greater than the &G command.
• Execute &W0 to initialize. (Refer to &W command.)
•Note: For details of the picture frame adjustment procedure, refer to ''Picture Frame Adjustment Procedure".
•Note: To end the adjustment, be sure to input .
If is not input, commands input thereafter may not be executed.
•Note: If the power is cut in this state, the new screen start position data will not be saved. To save the data,
execute &W1 . (Refer to the &W command.)
Magnified image