158
MVP MANUAL
9. INSTALLING AND REMOVING BOARDS
(Fig. A)
(Fig. B)
(Fig. C)
Screw (3x6)x6

<Removal procedure>

1Remove the front panel.
2Remove the screws fastening the board to the
removed. (Fig. C)
3Lift the ejectors indicated with white arrows. (Fig.
B)
4Gently draw out the board along the rails.
5Set the front panel back in place.

For your safety

ΒΆBe sure to turn the power off before installing
and removing boards.

<Installation procedure>

1Remove the screws from the front panel, then
open the front panel. (Fig. A)
2Insert the board gently along the rails.
Refer to the board layout for the positions for in-
serting the boards.
3Press the part of the white plastic part
strongly with a finger and insert the board fully
to the back. (Fig. C)
* The board may not go fully to the back if pressed
on the metal part.
4Fasten with the flanged screws (3x6). (Fig. C)
5Set the front panel back in place.