• The charging cycle will start automatically as soon as you insert a transmitter or re-
ceiver with a BP 4000 inside or a BP 4000 into the charger.
4 Charging
CCHHAARRGGEERREECCOOVVEERRSSttaattuuss
orange --- The inserted device is being
checked.
The test takes about 4 to
10 seconds.
red --- The BP 4000 is being
charged. The charging time
for completely discharged
batteries is approx. one
hour and proportionately
less for partially discharged
batteries.
green --- The BP 4000 is fully
charged; the charging cycle
is completed. The charger
switches to trickle charging
mode.
You may remove the device
or BP 4000 from the
charger.
4.4 Normal Charging Cycle
Table 2: Normal charging
cycle (for a BP 4000 with
sufficient residual voltage)
Note:
4.5 Initial Charging Cycle
for New or Deep-dis-
charged Battery Packs
Table 3: Charging a new or
deep-discharged BP 4000
(residual voltage too low)
21CU 4000
CHARGE RECOVER Status Action
orange --- The inserted device
is being checked.
The test takes about
4 to 10 seconds.
---
>orange< --- The BP 4000 is
being initialized.
---
red >orange< The BP 4000 is
being charged, and
a recovery cycle is
recommended.
Press and hold the
RECOVER key next
to the flashing
RECOVER LED.
red >green< The BP 4000 is
being charged and
the RECOVER LED
indicates the RE-
COVER key is being
pressed.
Hold the RECOVER
key for at least
3 seconds.
red red The recovery cycle
has started. The BP
4000 is charged for
a few minutes if re-
quired.
Release the
RECOVER key.
>red/orange< red Recovery cycle: the
BP 4000 is being
---
BDA CU 4000_Hex_D030929:Layout 1 15.12.2009 15:44 Uhr Seite 21 (Schwarz/Black Auszug)