4.6 Recovery Cycle
Note:
Table 4: Recovery cycle
4 Charging
Partially discharging the BP 4000 many times may reduce its capacity (memory effect) or
affect the accuracy of the remaining-capacity display.
The recovery cycle performed by the CU 4000 charger reduces the memory effect and re-
stores the accuracy of the remaining-capacity display.
After approx. every 16 partial-discharge cycles, the device display will indicate "Err.Acc" and
"--.-" instead of the hour display. (The remaining battery capacity will only be indicated by
the bar graph.) Once you insert the device into the charger, the RECOVER LED will start
flashing orange.
These messages request you to start a recovery cycle as soon as possible. The charger will
not perform a recovery cycle before you have pressed the RECOVER key for at least 3 sec-
onds.
In most cases, the "Err.Acc" or “Rec.Acc” message in the device display is only a re-
quest to perform a recovery cycle rather than an error message!
However, if the "Err.Acc" message comes up again when you power the device up
after a successful recovery cycle (the RECOVER LED will not flash orange on inserting
the device), there may be a communication pr oblem between the device a nd the
BP 4000. In this case, please contact your nearest AKG Service Center.
23CU 4000
CHARGE RECOVER Status Action
orange --- The inserted device
is being checked.
The test takes about
4 to 10 seconds.
---
red >orange< The BP 4000 is
being charged, and
a recovery cycle is
recommended.
Press and hold the
RECOVER key next
to the flashing
RECOVER LED.
red >green< The BP 4000 is
being charged and
the RECOVER LED
indicates the
RECOVER key is
being held down.
Hold the RECOVER
key down for at
least 3 seconds.
red red The recovery cycle
has started. The
BP 4000 is charged
for a few minutes if
required.
Release the
RECOVER key.
>red/orange< red Recovery cycle: the
BP 4000 is being
discharged.
---
red
>red/orange<
red
red
Recovery cycle: the
BP 4000 is being
charged for the first
time.
---
Recovery cycle: the
BP 4000 is being
discharged.
---
BDA CU 4000_Hex_D030929:Layout 1 15.12.2009 15:44 Uhr Seite 23 (Schwarz/Black Auszug)