Alamo GR72, GR60 manual Assembly

ASSEMBLY

Stabilizer Bars or Sway Chains must be installed and adjusted tightly. Without these bars or chains, serious damage to the Driveline can occur, and broken parts could cause bodily injury to the operator or bystanders. Stabilizer Bars or Sway Chains are available at most tractor dealerships.

4.Raise the Cutter to check clearance between the Driveline and Cutter Deck. Set the lift stop on the tractor to ascertain that the Driveline does not strike the deck.

Front Deflectors (Standard Equipment) and Chain Guards(Optional Equipment at Extra Cost)

Front and Rear rubber-fabric Deflectors are Standard Equipment and Front and Rear Chain Guards are optional . One type of guard must be installed (and maintained in good repair) except for agricultural purposes only in areas where persons, vehicles, livestock, or other property will not be endangered by thrown objects and where such safety equipment would prevent the mower's reasonable performance of its assigned agricultural task. Assy01-Shielding

Deflectors: Front and Rear Deflectors (Standard Equipment) are recommended for the average user and will provide protection from thrown objects with proper operation under normal conditions. Deflectors must be maintained in good repair or replaced after no more than two inches of wear off lower edge.

Front Rubber Fabric Deflectors (Standard Equipment)

Front Deflector (Figure Asm-0003)

1.Attach the Front Bracket (1) to the front of the mower with 1/2" x 3" Bolts (3), Flatwashers (9) and Locknuts (4).

2.Attach the Front Deflector (2) to the Bracket with 3/8" x 1-1/2" Bolts (5), Woodwashers (8), Flatwashers (6), and Locknuts (7).

GR60/72 02/07 Assembly Section 3-5

© 2007 Alamo Group Inc.

ASSEMBLY