ASSEMBLY
ASSEMBLY
Driveline Attachment - GR60 (Figure Asm-0051)
Before starting assembly, make certain that all paint, dirt, and grease are removed from gearbox shaft (1). To ease assembly apply a light coat of grease to splines and assemble. Do not assemble a driveline without a shield. Entanglement in rotating shafts can kill.
1.Attach the slip clutch end of the driveline to the gearbox input shaft securely. Make certain that the slip clutch is fully onto the input shaft splines. Tighten the locknuts (2) alternately until they have reached the proper torque. Refer to Torque Chart in the Maintenance Section.
Driveline Attachment - GR72 (Figure Asm-0044)
1.Remove washer, castle nut, and cotter pin from gearbox shaft. Install clutch yoke on shaft. Attach yoke to clutch by inserting spacer flat (#1) between yoke and clutch. Insert 5/16 x 3- 1/2 bolts (#2) and install locknuts (#3). Tighten securely. Install washer and castle nut on gearbox shaft between yoke ears. Tighten Mounting Nut and then back off to allow approximately .015 clearance.
GR60/72 02/07 | Assembly Section |
© 2007 Alamo Group Inc.
