ASSEMBLY

ASSEMBLY

A-Frame Assembly (Figure Asm-00049)

To assemble the Mower’s A-Frame, follow the procedures listed below:

1.Attach the mower’s right and left upright braces

(1)to the mower deck frame with one 5/8x 2” bolt (7) and locknut (9) one each side as illus- trated in Asm-0049.

2.Place the Flexible Hitch Top Link (3) and inner Bushing (4) between the right and left upright braces. Position the A-frames two Long Braces

(2)on the respective outside of the Upright Braces (1). Insert one 3/4 x 6” bolt (5) through all four braces and inner bushing. Attach and tighten locknut (6) to bolt (5).

NOTE: The Flexible Top Link (3) must be free to pivot for the mower to follow the contour of uneven ground. If unable to pivot freely, loosen top link bolt

(5) and nut (6).

3.Align the free end of the Long Braces (2) to the respective sides of the mower deck support lugs as illustrated. Align holes of Long Braces and mower deck Lugs and insert one 5/8 x 1-1/ 2” bolts (10) and locknuts (11) to each side. Tighten bolts securely.

4.Insert hitch pins for CAT I and II (12) into the top front holes of lift Lugs and retain using Lynch Pins (13).

GR60/72 02/07

Assembly Section 3-2

© 2007 Alamo Group Inc.

Page 76
Image 76
Alamo GR60, GR72 manual Frame Assembly Figure Asm-00049