Chapter 4, Formatting Tape

4.1A PULL-UP AND PULL-DOWN SAMPLE RATE SELECTION

The Sample Rate button is also used to select the respective 0.1% pull-up and pull-down rates. A pull-up is available with a 30 fps SMPTE rate only. A pull-down is available with a 29.97 fps SMPTE rate only.

Use pull-up or pull-down after a standard tape format: It is not necessary to pre-select a pull-up or pull-down prior to formatting since the “pull” status is not recalled when tapes are subsequently reinserted. Use the pull-up/pull-down feature after formatting your tape. If you are formatting and recording simultaneously, using the pull-up/pull-down feature may be appropriate.

Operation

You press…

You see…

Select a Pull-up

…and hold

“+0.1%” displayed in the Sample Rate

sample rate

Sample Rate

block

 

button then press

 

 

Up button

 

Select a Pull-down

…and hold

“- 0.1%” displayed in the Sample Rate

sample rate

Sample Rate

block

 

button then press

 

 

Down button

 

Return to a normal

…and hold

Sample Rate block returns to normal

44.1/48 kHz sample

Sample Rate

sample rate display (44.1 or 48 kHz)

rate from a “pulled”

button then press

 

rate

the 0/Space

 

 

button

 

Refer to section 16.4 for more information on pull-up and pull-down.

4.2WORD LENGTH SELECTION

Select 20 bits unless you want compatibility with older, Type I format ADAT tapes.

Operation

You press…

You see…

Initiate word length

Edit button, then

Display says “Format Data Type” and

selection

Format button

16 or 20 bits

Select word length

Up or Down

The desired word length (16 or 20)

 

Arrow button so

 

 

that the display

 

 

shows…

 

ALESIS M20 REFERENCE MANUAL 1.06

4-3

Page 31
Image 31
Alesis ALESIS M20 owner manual Word Length Selection, 1A PULL-UP and PULL-DOWN Sample Rate Selection, Formatting Tape