Alliance Laundry Systems 512685R2 manual 21

Installation

Connecting Power Cord with Three-Wire Plug

NOTE: Four-wire cord is required for mobile homes or where codes do not permit grounding through neutral.

NOTE: The power cord is NOT supplied with the
electric dryer. Type of power cord and gauge of wire
must conform to local codes and instructions.					POWER SUPPLY			POWER SUPPLY
The method of wiring the dryer is optional and subject								1
to local code requirements.
NOTE: Connect the dryer to the power supply with the								2
MAXIMUM RATED VOLTAGE listed on the nameplate.								3
			A typical	INTERMEDIATE
			30-Amp								INTERMEDIATE
			Three-Wire	FUSE BOX (may
											SHUT-OFF BOX
			Receptacle	be omitted if
								4			(may or may not
			NEMA Type	service entrance
			10-30R	box is fused)							be fused)
				WALL
		120 ± 12		RECEPTACLE				5
	120 ± 12							6
			V.A.C.
	V.A.C.							7
		240 ± 12
		V.A.C.
NOTE: Use COPPER WIRE only.						L1	L2		L1	L2
					POWER CORD CONNECTION			DIRECT CONNECTION
Shorter than 15 ft. (4.5 m) – use 10 AWG

Longer than 15 ft. (4.5 m) – use 8 AWG

D816I

1	3 Wire Grounded Neutral 120/240 Volt, 60 Hertz	4	Metallic or Non-Metallic Sheathed Cable
	AC 1 Phase Service Entrance Switch Box		(Copper Wire Only)
	(Refer to NOTE above)	5	Power Cord (Not supplied with dryer)
2	30 Ampere Fuses or Circuit Breaker	6	Neutral
3	Neutral Wire	7	Terminal Block in Dryer

1.Disconnect power to dryer.

2.Remove access cover from rear of dryer.

Figure 11

3.Use a strain relief and insert end of power cord through power supply hole.

D696I

D695I

Figure 13

Figure 12

512685 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 19