Alliance Laundry Systems 512685R2 Slide Extension

Slide Extension

(Coin Slide Models)

1.Remove slide extension parts from parts accessories bag included in unit.

2.If installing a Greenwald coin slide, position extension lever (to be installed on extension bracket) with arm that has one star facing down. Refer to Figure 35.

GREENWALD	MONARCH OR ESD
COIN SLIDE	COIN SLIDE

ONE STAR	TWO STARS

TLW2088N

Figure 35

3.If installing a Monarch or ESD coin slide, position lever with arm that has two stars facing down. Refer to Figure 35.

4.Install extension lever with rounded corner facing away from extension bracket using bolt, one or two flat washers (shims) (use number of washers included in kit) and nut. Refer to Figure 36. Make sure washers are flat against bracket.

		ONE OR TWO
SPRING	BOLT	FLAT WASHERS (SHIMS)
		ROUNDED CORNER
LOOPS		NUT
LOOPS

EXTENSION BRACKET	EXTENSION LEVER
	EXTENSION LEVER
	TLW2089N
	STAR(S) FACING DOWN
	TL2089N

Figure 36

5.Torque nut between 2 and 2.26 Nm (18 and 20 inch-pounds), or tighten nut firmly.

Vending

6.Install extension spring in bracket hole and hole in upper arm of lever. Refer to Figure 36.

7.Bend loops closed after installation.

8.Check to make sure the lever swings freely.

Installing Extension Onto Coin Slide:

Option 1

1.Install slide extension onto top of coin slide using two remaining screws and lockwashers. Refer to Figure 37.

ATTACHING

SCREWS

LOCKWASHERS

COIN SLIDE

SLIDE

EXTENSION

TLW1564K

Figure 37

2.Insert coins and partially extend coin slide.

3.Insert coin slide on its side through meter case opening. Then rotate 90 degrees to its proper orientation.

4.Return coin slide and hook slide pins onto meter case.

5.Continue coin slide installation according to manufacturer’s instructions.

512685