Lint Filter

CLEAN THE LINT FILTER BEFORE DRYING EACH LOAD. (Refer to Figure 69 for lint filter location.) Cleaning the lint filter is important because a layer or pad of lint on the filter will block the flow of air through the dryer, thus reducing the efficiency of the dryer. The clothes will take longer to dry and energy will be wasted.

The lint filter may be washed if needed. Annually remove lint filter and screw to vacuum the duct under it.

1

D608I

D608I

1Lint Filter

Figure 69

Motor Overload Protector

The dryer’s motor overload protector stops the motor automatically in the event of an overload. After cooling, the overload protector will reset itself. Dryer can be restarted by pressing the PUSH-TO-START button or START pad. If overload protector cycles again, remove the dryer from use and call the service person to correct the problem.

For Energy Conservation

Make sure the lint filter is always clean.

Do not overload dryer.

Do not overdry clothes.

Remove items to be ironed while still damp.

Large loads of similar fabrics dry the most efficiently. However, dry permanent press in smaller loads to prevent wrinkling.

Use the correct temperature FABRIC SELECTOR setting for the type of fabric being dried.

Locate your dryer so the exhaust duct is as short and straight as possible.

Do not open the door during the drying cycle.

Plan to do your laundry on low humidity days; your clothes will dry faster.

Should you plan to dry several loads, do them one after another, then you do not have to reheat the dryer unit’s interior parts each time.

44

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

512685