Alliance Laundry Systems 512685R2 Vending, Coin Slide Guards, Coin Slide Control

Vending

Coin Slide Guards

(Metered Models)

Using sheet metal screws from accessories bag (located in lower cylinder), install coin slide guards (located in accessories bag in lower cylinder) to front of dryer’s control cabinet. Refer to Figure 33.

	1		1
		PERM PRESS	DELICATE
		NORMAL	FLUFF
			(NO HEAT)
		IN USE
		FABRIC SELECTOR
		PUSH TO START
	PUSH TO START
	PERM PRESS	DELICATE	IN USE
			IN USE
	NORMAL	FLUFF
		(NO HEAT)
	FABRIC SELECTOR
	2		2
	2
			D784I
			D784I
1	Coin Slide Guard	2	Sheet Metal Screws

Figure 33

NOTE: Coin slides and coin drawers are shown for illustration only. You must obtain them locally.

Coin Slide Control

(Coin Slide Models Only)

Power-Up Mode

When power is applied to the dryer, the control will enter the Ready Mode. If the control was powered down during a running a cycle, the IN USE LED will flash once and the control will enter Start Mode. If the dry time dipswitch settings have not been changed from factory default, the IN USE LED will flash once.

Ready Mode

In Ready Mode, the control waits for the vend to be satisfied before entering Start Mode.

Start Mode

In Start Mode, the vend has been satisfied, but the Start button has not been pressed. The IN USE LED will be lit. The timer will not count down until the Start button is pressed.

Run Mode

In Run Mode, the control is running a cycle. The IN USE LED is lit.

Door Open Mode

In Door Open Mode, the control turns off the heater and motor when the door is opened during a run cycle. The timer will continue to count down time and the IN USE LED is lit.

End of Cycle Mode

In End of Cycle Mode, a cycle is complete and the IN USE LED is off. The control remains in this mode until the door is opened or additional vend has been satisfied.

512685