Alliance Laundry Systems 512685R2 Step 7: Plug In the Dryer, Step 6: Wipe Out Inside of Dryer

8.Using screwdriver, remove two door plugs, and reinstall on opposite side of door opening.

D317S

Figure 27

9.Reinstall four hinge attaching screws, removed in Step 1.

D606ID606I

Figure 28

Step 6: Wipe Out Inside of Dryer

Before using dryer for the first time, use an all-purpose cleaner, or a detergent and water solution, and a damp cloth to remove shipping dust from inside dryer drum.

D604I

Figure 29

Installation

Step 7: Plug In the Dryer

Electric Dryer

Connect the dryer to an electrical power source. Refer to Step 4 for information on connecting power cord.

Connect to 30 Amp circuit.

D275I

Figure 30

Gas Dryer

Dryer requires 120 Volt, 60 Hertz electrical supply and comes equipped with a 3-prong grounding plug. Refer to serial plate for specific electrical requirements.

NOTE: The wiring diagram is located inside the control hood.

WARNING

To reduce the risk of fire, electric shock, serious injury or death, all wiring and grounding MUST conform with the latest edition of the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1, and such local regulations as might apply. It is the customer’s responsibility to have the wiring and fuses installed by a qualified electrician to make sure adequate electrical power is available to the dryer.

W521

When plugging in the dryer:

•Do not overload circuits.

•Do not use an adapter.

•Do not use an extension cord.

•Do not operate both a washer and gas dryer on the same circuit. Use separetely fused 15 amp circuits.

512685