Alliance Laundry Systems CHM166C manual

Washer-Extractors

Cabinet Hardmount Operating Instructions

This manual is only a Supplement. Refer to Installation Manual and Operation/Maintenance Manual for full instructions.

CHM166C

Keep These Instructions for Future Reference.

(If this machine changes ownership, this manual must accompany machine.)

www.comlaundry.com	Part No. F232145R6EN
	November 2005

Supplement Installation/Operation

Contents

Page Page Table of Contents Notes Safety Information Important Safety Instructions Page Specifications and Dimensions 2 Speed Models (Continued) Door Opening Information Power Consumption Drive Train Information Cylinder Speeds Balance Detection Direct Steam Heating (Optional) Electrical Heating (Optional) Gap Setting for Vibration Switch (Variable-Speedand Fixed-SpeedModels) Table 3 (Continued) Page For 18, 20, 25, 27, 30 and 35 Pound Capacity Machines For 40 and 50 Pound Capacity Variable-Speed and Fixed-SpeedMachines For 60 Pound Capacity Variable-Speedand Fixed-SpeedMachines For 80 Pound Capacity Machines For 125 Pound Capacity Machines Dimensional Clearances Dimensions Machine Capacity Dimensions Dimensions 125 Model Electrical Specifications Page Page Page Page Operation Symbol 30C Description Instructions for EDC Control For machines equipped with a cardreader: If display flashes “SPEC” then “CYCL”, extra options such as 10.Add bleach to container 2 when ADD BLEACH light is lit. Refer to Figure 11. Cycle is complete when display reads “:00” Instructions for Mechanical Timer 5. Select wash cycle. Refer to Figure a.Add detergent to container b.Add softener to container For coin models: For non-coinmodels: Press the Start button. Refer to Figure Instructions for S, P and V Series Microcomputers 5.Add liquid and/or powder supplies to supply dispenser. Refer to Figure 6.Press the Up and Down keys to select wash cycle. Refer to Figure 8.For non-coinmodels: Press the Start key. Refer to Figure When applicable NOTE: To stop a cycle at any time, press the Stop key. Non-coinmodels only Instructions for B Series Microcomputer Page Instructions for A Series