Alliance Laundry Systems CHM166C Instructions for A Series, Microcomputer

Instructions for A Series

Microcomputer

NOTE: Opening the coin box while in Run Mode and before a cycle has started will put control into Audit Mode. Display will show “Audt”. To revert back to Run Mode, close coin box and press START keypad.

1.Turn on main power source (circuit breaker).

2.Push button and turn handle clockwise to open. Refer to Figure 36.

U001I

Figure 36

3.Load to capacity whenever possible. DO NOT OVERLOAD. Refer to Figure 37.

U003I

Figure 37

Installation/Operation Supplement

4.Close door and turn handle counterclockwise until button pops out. Refer to Figure 38.

U005I

Figure 38

5.The default wash cycle will display. Refer to Figure 39.

NOTE: The default cycle is Perm Press 60°C for coin models if no cycle is selected.

CHM1759C

Figure 39

F232145 (EN)

Contents

Page Page Table of Contents Notes Safety Information Important Safety Instructions Page Specifications and Dimensions 2 Speed Models (Continued) Door Opening Information Power Consumption Drive Train Information Cylinder Speeds Balance Detection Direct Steam Heating (Optional) Electrical Heating (Optional) Gap Setting for Vibration Switch (Variable-Speedand Fixed-SpeedModels) Table 3 (Continued) Page For 18, 20, 25, 27, 30 and 35 Pound Capacity Machines For 40 and 50 Pound Capacity Variable-Speed and Fixed-SpeedMachines For 60 Pound Capacity Variable-Speedand Fixed-SpeedMachines For 80 Pound Capacity Machines For 125 Pound Capacity Machines Dimensional Clearances Dimensions Machine Capacity Dimensions Dimensions 125 Model Electrical Specifications Page Page Page Page Operation Symbol 30C Description Instructions for EDC Control For machines equipped with a cardreader: If display flashes “SPEC” then “CYCL”, extra options such as 10.Add bleach to container 2 when ADD BLEACH light is lit. Refer to Figure 11. Cycle is complete when display reads “:00” Instructions for Mechanical Timer 5. Select wash cycle. Refer to Figure a.Add detergent to container b.Add softener to container For coin models: For non-coinmodels: Press the Start button. Refer to Figure Instructions for S, P and V Series Microcomputers 5.Add liquid and/or powder supplies to supply dispenser. Refer to Figure 6.Press the Up and Down keys to select wash cycle. Refer to Figure 8.For non-coinmodels: Press the Start key. Refer to Figure When applicable NOTE: To stop a cycle at any time, press the Stop key. Non-coinmodels only Instructions for B Series Microcomputer Page Instructions for A Series