Manuals / Brands / Laundry Appliance / Washer/Dryer / Alliance Laundry Systems / Laundry Appliance / Washer/Dryer

Alliance Laundry Systems CHM166C Instructions for Mechanical Timer, For, For, models:, models:, non-coin, non-coin

1 38

Download 38 pages, 1.21 Mb

Instructions for Mechanical Timer

1.Turn on the main power source (circuit breaker).

For non-coin models: Turn on the On/Off switch on the front panel to the On position.

2.Push button and turn handle clockwise to open. Refer to Figure 16.

U001IE1B

Figure 16

For non-coin models: Press and hold the DOOR UNLOCK button on the left side of the control panel while performing the above step. Refer to Figure 17.

DOOR UNLOCK

Off

U135R

Figure 17

Installation/Operation Supplement

3.Load to capacity whenever possible. DO NOT OVERLOAD. Refer to Figure 18.

U003IE1A

Figure 18

4.Close door and turn handle counterclockwise until button pops out. Refer to Figure 19.

U005IE1B

Figure 19

F232145 (EN)

Contents

Page Page Table of Contents Notes Safety Information Important Safety Instructions Page Specifications and Dimensions 2 Speed Models (Continued) Door Opening Information Power Consumption Drive Train Information Cylinder Speeds Balance Detection Direct Steam Heating (Optional) Electrical Heating (Optional) Gap Setting for Vibration Switch (Variable-Speedand Fixed-SpeedModels) Table 3 (Continued) Page For 18, 20, 25, 27, 30 and 35 Pound Capacity Machines For 40 and 50 Pound Capacity Variable-Speed and Fixed-SpeedMachines For 60 Pound Capacity Variable-Speedand Fixed-SpeedMachines For 80 Pound Capacity Machines For 125 Pound Capacity Machines Dimensional Clearances Dimensions Machine Capacity Dimensions Dimensions 125 Model Electrical Specifications Page Page Page Page Operation Symbol 30C Description Instructions for EDC Control For machines equipped with a cardreader: If display flashes “SPEC” then “CYCL”, extra options such as 10.Add bleach to container 2 when ADD BLEACH light is lit. Refer to Figure 11. Cycle is complete when display reads “:00” Instructions for Mechanical Timer 5. Select wash cycle. Refer to Figure a.Add detergent to container b.Add softener to container For coin models: For non-coinmodels: Press the Start button. Refer to Figure Instructions for S, P and V Series Microcomputers 5.Add liquid and/or powder supplies to supply dispenser. Refer to Figure 6.Press the Up and Down keys to select wash cycle. Refer to Figure 8.For non-coinmodels: Press the Start key. Refer to Figure When applicable NOTE: To stop a cycle at any time, press the Stop key. Non-coinmodels only Instructions for B Series Microcomputer Page Instructions for A Series